Press "Enter" to skip to content

Installing A Motion Sensor Light Switch

admin 0

Certainly one of the simplest ways to lower the quantity of electricity that you use in your house is to show off lights and appliances when you aren’t using them. That being said, this is something that many homeowners find easier said than done. Luckily for you, there are quite a lot of devices available now that can assist you to in your attempt to shut off all devices when not in regular use. Options range from simple power strips, to timed lights and outlets to smart strips that turn all the way off when reduced electrical current is detected. One very handy way to regulate lighting in a certain area is with a motion sensor light switch. This enables you to simply turn lights on and off whenever someone enters and leaves a room. Follow these steps to put in one.

Step 1: Shut Off Power

Gold 1 Gang 1 Way Wall Touch Switch WirelessBecause you might be dealing with electrical components, you will want to determine which circuit breaker controls this particular switch and shut it off at the electrical panel. If you are worried about someone coming along and flipping that breaker back on before you are finished, tape over the breaker and leave an indication that claims “do not touch!”

Step 2: Remove the Old Switch and Test the Wires

Start by taking the wall plate off of the current switch and testing the wires with a circuit tester. It will be sure that there is certainly no power running through this particular circuit. In case you are using an audible tester, a continuous beep typically indicates that there continues to be power. Your tester should confirm your belief that the circuit has been shut off. You can now remove the screws holding the switch in its box and pull it out.

Step 3: Disconnect Wires

Your old switch should have three different wires connected to it: a black wire, a bare ground wire and a white wire. You’ll need to use the black and white wires with the motion sensor switch, but not the bottom. Disconnect or cut these wires at the back of your old switch. It’s best to then strip the wires to allow for correct connectivity to the new motion-sensor switch.

Step 4: Connect Your New Switch

Now that you’ve stripped your wires, you may connect them to your new switch. Start by wrapping the black wire snugly around the suitable wire connection on the back of the switch. Do the same with the white wire and secure them with wire connectors.

Step 5: Insert The Switch

After everything has been connected, tuck the switch back into the box. You’ll be able to then secure it with the provided screws.

Step 6: Customize and Enjoy

After your switch has been installed, you can spend a little time customizing it in order that it provides the level of sensitivity that you are in search of. When properly adjusted, your motion sensor light should trigger your lights on whenever someone enters the room. It will then shut the light off after a given time frame, as long as no new motion is sensed.

Leave a Reply

Your email address will not be published. Required fields are marked *