Press "Enter" to skip to content

To alter To alter A Light Switch At Home

admin 0

Wireless Touch Switch Black 3 GANG 1 WAY Remote Light Switch

You will need insulated, pointed, electricity pliers, a screwdriver, a sharp knife and good quality electric tape. The first and most important step to take is to turn the electric power off to the realm or switch you will be changing. Turn the sunshine on, now go to the electric panel and throw the breaker switch to which the lamp is attached. If they don’t seem to be labeled properly, turn them off one by one checking if the light went off inside. When it goes off, you’ve found the suitable breaker switch. If you do not need to do that, throw all the circuit breakers off.

Now using the screwdriver, remove the screws attaching the switch to the electric box in the wall. Pull it out and take an excellent take a look at all the wires screwed to the sides of the switch. They need to have different colors for proper identification, if they do not you’ll be able to still do the job, do not worry. Compare the screws of the brand new switch to those of the old switch, be sure that they’re located in the same place and that there is similar number of screws. They’ll all be the identical color with the exception of the bottom screw which shall be green.

Here I will take a break from the method and explain a bit of something which is very important. If you are changing a light switch that is the only one used to show a lamp on and off, any switch will do. When the lamp might be turned on from two or more switches located in numerous areas of the room, a special switch is needed. If this is the case make sure you tell this to the attendant at the hardware store so he sells you the precise type of switch. This isn’t any big deal; they’re just different and have an extra wire connection.

Okay, back to work, the electricity is off and the switch is off the wall too. Take a superb look at the wire distribution on the used switch identifying every wire and where it is connected. Loosen the primary screw on the used switch, using the pliers take it off the holding screw. Using the pliers straighten the wire out and with the night scrape the tip of it so it’s shiny and clean again. Make a u shape on the tip and put it around the identical screw on the brand new light switch. Ensure that the u is tight against the screw base; tighten the screw until the wire is firmly in place. Do the same for all the opposite screws. Now take the electric tape and wrap the sides of the switch with a few turns covering the screws and the wires. This can be a precaution in case that for some reason the screws touch the metal electric box within the wall.

Screw the switch tightly in place and put the cover on. Activate the circuit breakers within the electric panel and test your new light switch. You’ve gotten now become an electrician; you are now able to alter any light switch in your home, freed from charge by yourself time. Congratulations you have got mastered your fear of electrocution by switch change.

Leave a Reply

Your email address will not be published. Required fields are marked *