Press "Enter" to skip to content

4 gang remote control light switch,wireless touch light switch

admin 0

wireless 1 gang light switch, 4 gang remote control light switch,Wholesale Glass Touch Switch Light – Buy Cheap Glass Touch Switch Light from Chinese Wholesalers,

To build To build A Simple Home Network System

Many individuals have relatively uncomplicated needs for his or her home networks. Even now that multiple computers within a single home are common, the systems are sometimes not networked, with file transfer being done by way of “sneaker net”, or copying files to and from a CD or by Sending files via email.

Gold 1 Gang 1 Way Wall Touch Switch WirelessThis is a good time to build your individual home network, when you have always wanted to. The prices and the complexity of the systems are lower than ever. Just getting past the technical terminology used is the largest barrier for many new home network builders. The equipment you’ll need is pretty simple. You’re going to want Cat-5 (or Ethernet) cables for a wired network. Think about where you plan to set up your computers to find out how much cable you’re going to want and then add on about 1/5 more cable than that – you always need a bit greater than you think. If you happen to plan to construct a wireless network, you may skip the cables.

You may also need a switch or a router for all of these cables (or radio waves if it’s a wireless network) to connect with. A hub or a switch is only a box with ports to plug cables into – a switch has slightly more functionality than does a hub. A router is best and may handle internet connection sharing; it is nearly a must for a house network. I say almost because you should use one of many computers on your network to handle internet connection sharing. However, it is typically far easier to simply use a router instead of tying up lots of the resources of considered one of your computers coping with connection sharing.

You are also going to need Network Interface Cards (or NICs) in each computer, printer or every other device you need to be on the network. These could be your standard 10/100 ethernet cards or 802.11b/g cards which can be utilized for a wireless network. In case you are building a wired network, you should use Ethernet equipment with 10MB or 100MB speeds. They are both so inexpensive, that there 4 gang remote control light switch is actually no reason to not go for the 100MB equipment. These devices generally support equipment which runs in the older standard as well. There can also be Gigabit Ethernet, but that is prohibitively expensive for many building a house network.

Install, attach and/or setup all hardware as per the manufacturers’ directions. Every device on the network needs to have a minimum of one IP address of its own. IP addresses are those numbers you might have seen on the internet before, corresponding to: 70-1-2-125. On a home network, your IP addresses will appear like 192.168.0.1 or 10.121.0.1.

Your IP numbering should begin with the router. This device is the center of your network; imagine a star with rays of light emanating from it. Each cable or wireless signal is one of these rays of light. The ends of those rays are where your devices are. If the router has the number 192.168.0.1, then computers and other device needs to be numbered 192.168.0.2, 192.168.0.3. Don’t assign the same address to two devices.

You may need to read the manual in your router for the specifics on easy methods to assign these addresses, as well as the documentation on your computer’s operating system.

4 gang remote control light switch

Leave a Reply

Your email address will not be published. Required fields are marked *