Press "Enter" to skip to content

honeywell timer switch installation,wifi remote light switch

admin 0

low voltage touch switch, honeywell timer switch installation,CLIXMO ONE TOUCH FAN CONTROLLER SWITCH GLASS PANEL SATURN BLUE LED AUS STD!,

Find out how to Wire A Light Dimmer Switch

Wireless Touch Switch White 2 Gang 1 Way Touch Switch For LampA dimmer switch gives you much more control over your lights than you’ll get with a flip switch. In addition they save energy and extend the life of your light bulbs. Dimmer switches are only to be used with incandescent lights. Don’t use them with ceiling fans, appliances or fluorescent lights because you will destroy the dimmer and whatever it is connected to. Dimmer switches can replace either single-pole or three-way switches. Follow the steps below to learn how to replace both types.

Things You’ll Need
Screwdriver
Pliers
Wire stripper/cutter
Wire nuts
Instructions
Turn off power to the light circuit. Remove the cover plate from the light switch and then remove the light switch from the electrical box.

Replace a single-pole switch with a single-pole dimmer. Loosen the two terminal screws on the switch and remove the connected wires. Splice those same two wires to the 2 wires from the dimmer. If both dimmer wires are black, it would not matter how you connect the wires. If one dimmer wire is black and the other red, you should splice the black wire to the wire that brings the electricity from the service panel and the red wire to the wire that runs to the light fixture. If your dimmer has a bare or green ground wire, splice that to the bare wire from the service panel. Cover all splices with wire nuts, push the wires into the box and screw the dimmer to the box.

Replace a three-way switch with a three-way dimmer. The presence of a three-way switch (a switch with three screw terminals, not including the ground terminal) honeywell timer switch installation means that there is another three-way switch on that same circuit. Only replace one of these, it doesn’t matter which. Do not install more than one dimmer on the same circuit.

Remove the three-way switch from the electrical box and remove the wires from the terminals. Connect those wires to the identical locations on the dimmer switch, push the wires back into the electrical box and screw the dimmer to the box.

Do not replace a four-way switch with a dimmer. You may recognize a four-way switch by the two screw terminals on each side. For those who happen to have this type of switch, it means you also have not less than two other switches controlling the same light or lights. The two switches on either end of the circuit are three-way switches. Replace a type of switches with the dimmer.

Tips & Warnings
Always buy “heavy-duty” dimmers. When a light bulb burns out, there’s a surge on the line, and this surge can destroy a weaker dimmer.
Related Searches

Photo Credit Flickr,com/J. O’Connell
Promoted By Zergnet

honeywell timer switch installation

Leave a Reply

Your email address will not be published. Required fields are marked *