Press "Enter" to skip to content

lcd touch light switch,hic touch on switch model ge 10

admin 0

light switches with remote control, lcd touch light switch,Nothing could be further from the truth. View Clipsal Premium Switches on Gooston,

The way to Hook Up A Toggle Switch

Wireless Touch Switch White 1 Gang 1 way Touch Panel SwitchA toggle switch is a switch with two positions. In one position, it connects electrical power to a device. In the other position, the ability to the device is disconnected. The toggle switch has a tab or small lever that can be raised or lowered to position the toggle switch in its two positions. This connects and disconnects the contact points inside the toggle switch. An lcd touch light switch example of a toggle switch is a light switch. It connects power to a light bulb and disconnects it depending on the position of the switch. If in case you have a toggle switch and have to hook it up, all you need are just a few simple items.

Other Persons are Reading
Methods to Toggle a Switch Wiring for On-Off-On
The way to Hook Up a Rheostat
Things You may Need
Screwdriver
Wire strippers
Needle nose pliers
Soldering iron
Lead-free solder

Remove all power from the device during which you’re going to hook up your toggle switch. One of the best ways is to unplug the device. If its power is hard-wired in, you will need to turn off the circuit breaker.

Gain access to the toggle switch once power is removed by removing the housing on which the toggle switch is installed. Housings are usually secured with housing screws, so simply unscrew the housing and pull it away.

Take the wire with the ability coming into the housing, usually the black wire, and use wire strippers to strip a small length of insulation from the end, enough to wrap the exposed wire around a terminal. Wrap the wire around the middle terminal on the toggle switch through the use of needle nose pliers.

Strip a brief length of insulation from the wire that goes to the device the toggle switch is designed to turn on. Wrap the metal end of the wire around the upper terminal on the toggle switch.

Turn on the soldering iron. Solder the 2 wires at the two toggle switch terminals. For each terminal, touch it with the new tip of a soldering iron while at the same time applying a short length of lead-free solder to the terminal. Once the solder melts, remove the remainder of the length of the solder and the soldering iron.

Turn off the soldering iron. Return the housing to its original lcd touch light switch position and secure it with the screws you removed. Return power to the device by plugging it back in or turning on the circuit breaker. The toggle switch will now turn the device on or off.

Related Searches
References
Basic Toggle Switch Structure
Photo Credit morguefile
Promoted By Zergnet

lcd touch light switch

Leave a Reply

Your email address will not be published. Required fields are marked *