Press "Enter" to skip to content

remote switch using cell phone,ave touch switch price

admin 0

finger touch light switch, remote switch using cell phone,Buy 2 Ways Wireless Remote Control Light Touch Switch Spectrum,

How you can Wire A Ceiling Light Red Wire

Black 1 Gang 1 Way Wireless Touch Screen Light Switch 86Wiring color codes are standardized in North America. Black wires always signify the positive, or hot, leg of the present, while white wires signify negative, also called neutral or return. Ground wires are either left bare or covered with green insulation. When there’s an extra hot wire, it’s red. Ceiling fixtures almost always have a black and white wire. In rare instances, the kit may include a red and yellow wire instead. On this case, red is hot. An extra red wire within the electrical box might be an additional hot wire for a fan.

Things You may Need
Voltage tester
Pliers
3 wire caps
Screwdriver
Drill
Metal-boring drill bit
Ground screw
Red Wire within the Electrical Box

Test the wires within the ceiling box with a voltage tester. If there may be an additional red wire, it’s best to get a reading of 120 volts whenever you touch the terminals of the tester to the red and white wires. It needs to be identical to the measurement if you touch the ends of the black and white wires with the voltage tester.

Turn off the facility to the circuit, either by flipping a switch or turning off the breaker in the primary panel that controls the circuit. Check the wires again with the voltage tester remote switch using cell phone to verify that there is no such thing as a voltage reading.

Twist a wire cap onto the red wire, then push it into the box. Be sure that no metal shows outside the cap when it is fully tightened.

Use pliers to twist the black wire from the house circuit clockwise along with the black wire of the light. When they’re secure, twist on a wire cap. Repeat this process with the white wires. The sunshine may have a bare ground wire or one covered in green insulation. Twist it along with the bare wire from the house circuit, then screw on a wire cap.

Push the wires into the electrical box. Mount the sunshine fixture with the included hardware.
Red Wire on the sunshine Fixture

Turn off the power to the sunshine circuit, then check the wires with a voltage tester to verify there is no such thing as a voltage reading.

Twist the red wire from the sunshine fixture together with the black wire from the house circuit with pliers. Cap the wires.

Other Individuals are Reading
The best way to Wire White Wire to Brass
The best way to Ground a Ceiling Light
Twist the white wire from the house circuit together with the white or yellow wire from the sunshine, and cap them. If there’s a 3rd wire, it will likely be either bare, green or blue. Twist it together with the bare wire from the house circuit. If there isn’t a third wire, ground the fixture by attaching the bare wire to the metal base of the fixture. You will have to put in a ground screw.

Drill a hole slightly smaller than the diameter of a green ground screw within the metal base of the fixture. Screw in the ground screw. Wrap the bottom wire around it, then tighten the screw.

Tips & Warnings
Some low voltage lights have various colored wires, a few of that are used for dimming. Consult the instructions that came with the sunshine for the correct wire connections.
If the electrical box was previously used for a fan, the wall switch might be a two-pole switch. Either disconnect the red wire from the switch or replace the switch with a single-pole version.
Ensure the circuit power is off before you make any electrical connections. You’ll be able to receive a shock otherwise. In case you are standing on a ladder on the time, the shock may cause you to fall.
Related Searches
References
Electrical Online: How to put in a Ceiling Fan
Aubuchon Hardware: How to put in a Light Fixture

Photo Credit ceiling light view2 image by askthegeek from Fotolia.com
Promoted By Zergnet

remote switch using cell phone

Leave a Reply

Your email address will not be published. Required fields are marked *